<- sx:buses|Buses ^ sx:start|52/SX Configuration ^ sx:users|Users -> ======On-Air Switch====== The ''On-Air Switch'' page gives you the possibility to change sources for an output controlled by logic sources. [{{ :sx:sx_switch.png?nolink |//SXConfig Software - On Air Switch//}}] You can select three stereo audio sources, which can be switched by two logic sources. On the left-hand side you can see the audio sources of the On-Air switch. The black lines symbolise audio signal paths. There are two blue-coloured signal switches, each with an associated logic sources (see figure On-Air Switch configuration). [{{ :sx:on-air_switch_general.png?nolink |//On-Air Switch configuration//}}] To configure the On-Air switch, follow these steps: - Click the {{:sx:on-air_switch_dots.png?nolink}} button next to the ''Source 1L'' box, the ''Audio Sources'' window opens. - In the ''Audio Sources'' window, select a source and click ''Assign''. Alternatively you can double-click on the source or drag it to the ''Source'' box. The source is now assigned to the On-Air switch. - Repeat steps 1 and 2 for the ''Sources 1R, 2L, 2R, 3L'' and ''3R''. - The main switch on the right-hand side is assigned by default to the ''OnAir'' Logic Function. To change the logic source, click {{:sx:on-air_switch_dots.png?nolink}} and select another logic source from the ''Logic Sources'' window. - The switch between ''Source 1'' and ''Source 2'' has no default logic source and you have to select a logic source if ''Source 2'' will be used. Click {{:sx:on-air_switch_dots.png?nolink}} and select another logic source from the ''Logic Sources'' window. The main switch with its default logic source OnAir is already preconfigured in the 52/SX-System. To switch between ''Source 3'' and ''Source 1'' (or ''Source 2'') follow these steps: - On the TFT/Touch Display, on the main page, tap on ''add. Settings''. - Tap on the ''ON AIR'' button and press at the same time the ''OK'' key on the central module (52-1011). The ''ON AIR'' button turns red.'' Source 3'' is now selected. - To switch back to ''Source 1'' (or ''Source 2''), tap on the ''OFF AIR'' button and press at the same time the ''OK'' key on the central module (52-1011). The ''OFF AIR'' button turns green and the ''ON AIR'' button turns white.'' Source 1'' is now selected. In the ''On Air Switch Signal'' area, you can assign the On Air Switch Signal to the'' Selector List 1'' and ''Selector List 2''. You can find these lists on the ''Selector'' view of the TFT/Touch Display. The Label and color for the corresponding TFT buttons can be changed in the ''TFT Keyoptions'' area.