Operation Server & Operation Manager version 10.0 release notes
Important
This document covers changes introduced with version 10.0. These changes in Operation Server & Operation Manager were necessary due to improvements in security, stability and functionality of firmware and WebApps version 10.0.
Functional Range in version 10.0
The following functions are supported in Operation Server & Operation Manager version 10.0
- Routing software (52-8551, 52-8552)
- Scheduling software (52-8550)
- Monitoring software (52-8555)
- DSP Control software (52-8565, 52-8566)
- Snapshot Manager (52-8562) with reservations, see Changes and discontinuations in version 10.0 below
- User Management with reservations, see Changes and discontinuations in version 10.0 below
Changes and discontinuations in version 10.0
As stated, changes in Operation Server & Operation Manager were necessary due to improvements in security, stability and functionality of firmware and WebApps version 10.0.
User Management
User Management: Import & Upgrade
- Toolbox user accounts are not imported and available anymore during operation server setup
- Toolbox user accounts are removed when upgrading existing Operation Server / Operation Manager installations to version 10.0
- Use local Operation Manager users instead
User Management: Functionality
Snapshot Manager & Snapshot Server
- Snapshot owners now can only be local Operation Manager users
- Snapshots previously owned by Toolbox users are reset to owner
Administrator
- Server snapshots can only be viewed on the mixing console (
Load/Save Remote Snap
button list element), when set topublic editable
orpublic readable
. Use built in Authorisation system of toolbox and firmware instead. - Remote creation of snapshots from a device to the server is no longer possible. Create snapshots locally on the device and transfer them using Operation Manager.
Upgrade recommendations version 9.2 to version 10.0
We recommend starting with a clean installation of Operation Server & Operation Manager version 10.0 and importing your configuration as documented.
If starting with a clean version 10.0 installation is not possible:
- Before upgrading, create equal Operation Manager users and assign them to the correct rights groups as formerly used Toolbox user accounts
- Check snapshot owners and replace them by local Operation Manager users