<- dx:general|General information on Configuration ^ dx:start|52/DX Configuration ^ dx:system_settings|System Settings -> ======Hardware====== On the ''Hardware'' page you can set which 52/DX modules are connected to your system. [{{ :dx:hardware.png?nolink |//DXConfig Software - Hardware//}}] ===== Common Settings Area ===== In the Field ''Device name'', enter a distinctive device name for this 52/DX mixing console. ===== DX Type ===== ''Select Type'': * Select your DX Type. **Note**\\ Only the 52/DX type 52-1114 is available in stock and can be configured with DXConfig 8.1.x. Older 52-1104 52/DX consoles can only be configured with DXConfig 7.x ===== XS Core ===== Select your core type. (''52-1830'': 52/XS Core with integrated Multi I/O) **Note**\\ For 52/DX Bundles, only 52-1830 52/XS Core is avialable. * ''Use MADI Module 52-7321'': If your XS core is equipped with a MADI module 52-7321, please select this check box to enable the inputs and outputs for the ''I/O Settings'' tab. * ''Use Gigabit Audio 52-7391'': If your XS core is equipped with a Gigabit Audio SFP Module, this enables the inputs and outputs in the ''I/O Settings'' tab. Gigabit Audio is useful e.g. to interlink with other DHD devices. * ''Use Dante module 52-7080'': If your 52/XS core is equipped with a 52-7080 internal Dante module. ===== XS I/O connections ===== * ''APC 4'' Select an I/O type or set the value to'' (none)''. Default is ''(None)''. * ''APC 3'' Select an I/O type or set the value to'' (none)''. Default is'' (None)''. * ''APC 2'' Select an I/O type or set the value to'' (none)''. Default is'' (none)''. ===== Console Preview ===== Shows, how your configurated DX will look like.