<- dx:v7:general|General information on Configuration ^ dx:v7:start|52/DX Configuration ^ dx:v7:system_settings|System Settings -> ======Hardware====== On the ''Hardware'' page you can set which 52/DX modules are connected to your system. [{{ :dx:v7:hardware_v7_dx.png?nolink |//DXConfig Software - Hardware//}}] ===== Common Settings Area ===== In the Field ''Device name'', enter a distinctive device name for this 52/DX mixing console. ===== DX Type ===== ''Select Type'': * Select your DX control surface type. **Tip**\\ To configure an 52-1104 control surface, go to ''Options''>''Configuration'' and select the ''Product Filter''-Tab. Activate {{:wiki:rot.png?nolink}} ''show discontinued products''. All Module types are now visible. ===== XS Core ===== Select your core type. (''52-1804'': 52/XS Core with integrated Multi I/O) * ''Use MADI Module 52-1821'': If your XS core is equipped with a MADI module 52-1821, please select this check box to enable the inputs and outputs for the ''I/O Settings'' tab. * ''Use Gigabit Audio 52-7391'': If your XS core is equipped with a Gigabit Audio SFP Module, this enables the inputs and outputs in the ''I/O Settings'' tab. Gigabit Audio is useful e.g. to interlink with other DHD devices. ===== XS I/O connections ===== * ''APC 4'' Select an I/O type or set the value to'' (none)''. Default is ''(52-1335)''. * ''APC 3'' Select an I/O type or set the value to'' (none)''. Default is'' (None)''. * ''APC 2'' Select an I/O type or set the value to'' (none)''. Default is'' (none)''. **Tip**\\ When using older I/O Modules, they are not displayed by default. Go to ''Options''>''Configuration'' and select the ''Product Filter''-Tab. Activate {{:wiki:rot.png?nolink}} ''show discontinued products''. All Module types are now visible. ===== Console Preview ===== Shows, how your configurated DX will look like.