<- dx:start|DX Configuration Manual ^ dx:start|52/DX Configuration ^ dx:dx_module|52/DX control module -> ======XS2 Core - DSP unit====== The powerful 52/XS2 Core is an independent DSP system which does not require a PC for operation. There are no fans, hard discs or batteries inside the 52/XS2 Core and in the I/O boxes, allowing silent and low-maintenance operation directly in the studio. High-performance 40-bit floating-point digital signal processing for: * 3-band fully parametric equalizers, subsonic filter, dynamics, limiter, delay for all 16 fader channels, mono or stereo * 16 summing busses (stereo), Aux busses, clean feeds and PFL * 6 clean feeds (mix-minus, mono or stereo) * 4 monitoring busses for control room and studio support * flexible talkback, logic and GPIO system * integrated routing matrix * internal tone generator * Gigabit audio network for 512 input and 512 output channels for low-latency interconnection between 52/XS2 cores or to other DHD products * internal or external 48 kHz or 44.1 kHz sync Other features of the 52/XS2 Core: * highly efficient external wide-range power supply, Energy Star Level V, redundancy option * minimal system power consumption * expandable modular system allows optional integration of other DHD product lines * serial or TCP/IP interface options to radio automation or other external control systems **Tip**\\ For more information on the Core Types, see [[https://dhd.audio/products/cores/52xs2/|52/XS2 cores product information]]. ===== Recent XS2 Cores ===== The XS2 cores are the result of constant research and development of our products. In the following table the main features of the 52-1830 are listed. [{{:sx:52-1830_swx_rear-top-1b.jpg?nolink|//52-1830 rear view//}}] ^Feature^52-1830^ |support for redundant power supply|yes| |number of supported faders|8| |number of supported I/O boxes|3| |number of audio, power & control ports (APC)|4| |serial interface for external control|yes| |TCP/IP interface for external control|yes| |built-in Dante 4ch/4ch interface|yes|