<- sx:general|General information on Configuration ^ sx:start|52/SX Configuration ^ sx:system_settings|System Settings ->


======Hardware======

[{{ :sx:hardware.png?nolink |//SXConfig Software - Hardware//}}]

On the ''Hardware'' page you can set which 52/SX modules are connected to your system. 


===== Common Settings Area =====

In the ''Device name'' box, enter a distinctive device name for this 52/SX mixing console.


===== SX Fader Module =====

''Select Type'': 
    * In the left drop-down menu, select 52-1021 or 52-1025 depending on your fader modules.
    * In the right drop-down menu, select the number of faders.

===== XS Core =====

Select your core type. (''52-1810'': Standard 52/XS2 Core; ''52-1830'': 52/XS2 Core with integrated Multi I/O)

  * ''Use MADI Module 52-7321'': If your XS core is equipped with a MADI module 52-7321, please select this check box to enable the inputs and outputs for the ''I/O Settings'' tab.
  * ''Use Gigabit Audio 52-7391'': If your XS core is equipped with a Gigabit Audio SFP Module, this enables the inputs and outputs in the ''I/O Settings'' tab. Gigabit Audio is useful e.g. to interlink with other DHD devices.
  * ''Use Dante module 52-7080'': If your 52/XS core is equipped with a 52-7080 internal Dante module.


===== XS I/O connections =====
When you check ''Use 52-8511 PC TFT View Software'', you can additionally assign a hardware module to ''APC 1''. This is possible because in that case you do not need an 52-4018 TFT module.

<WRAP center round important 80%>
**Important**\\  52-8511 PC TFT View Software requires valid License!
</WRAP>
<WRAP center round tip 80%>
**Tip**\\  When using older I/O Modules, they are not displayed by default. Go to ''Options''>''Configuration'' and select the ''Product Filter''-Tab. 

Activate {{:wiki:rot.png?nolink}} ''show discontinued products''. All Module types are now visible.
</WRAP>
==== for 52-1810 DSP cores ====

  * ''APC 8'' |Select an I/O type or set the value to ''(none)''. Default is ''52-1335''.
  * ''APC 7'' |Select an I/O type or set the value to ''(none)''. Default is ''52-1335''.
  * ''APC 6'' |Select an I/O type or set the value to ''(none)''. Default is ''(none)''.

==== for 52-1830 DSP I/O cores ====

  * ''APC 4'' |Select an I/O type or set the value to ''(none)''. Default is ''(none)''
===== Console Preview =====

''Split'': Shows a split version of the control modules in the preview.
''Flat'': Shows the control modules build in a flat table installation frame instead of a console frame.