<- sx:v7:general|General information on Configuration ^ sx:v7:start|52/SX Configuration ^ sx:v7:system_settings|System Settings -> ======Hardware====== [{{ :sx:v7:hardware.png?nolink |//SXConfig Software - Hardware//}}] On the ''Hardware'' page you can set which 52/SX modules are connected to your system. ===== Common Settings Area ===== In the Field ''Device name'', enter a distinctive device name for this 52/SX mixing console. ===== SX Fader Module ===== ''Select Type'': * In the left drop-down menu, select 52-1020 or 52-1024 depending on your fader modules. * In the right drop-down menu, select the number of faders. ===== XS Core ===== Select your core type. Select 52-1804 if you want to configure a 4 fader mixer or select 52-1801 for 8-16 fader. * ''Use MADI Module 52-1821'': If your XS core is equipped with a MADI module 52-1821, please select this check box to enable the inputs and outputs for the ''I/O Settings'' tab. * ''Use Gigabit Audio 52-7391'': If your XS core is equipped with a Gigabit Audio SFP Module, this enables the inputs and outputs in the ''I/O Settings'' tab. Gigabit Audio is useful e.g. to interlink with other DHD devices. ===== XS I/O connections ===== * ''APC 8'' (not available when using 52-1804 XS Core)|Select an I/O type or set the value to'' (none)''. Default is'' 52-1330''. * ''APC 7'' (not available when using 52-1804 XS Core)|Select an I/O type or set the value to'' (none)''. Default is'' 52-1330''. * ''APC 6'' (not available when using 52-1804 XS Core)|Select an I/O type or set the value to'' (none)''. Default is'' (none)''. ===== Console Preview ===== ''Split'': Shows a split version of the control modules in the preview. ''Flat'': Shows the control modules build in a flat table installation frame instead of a console frame.