<- sx:start|SX Configuration Manual ^ sx:start|52/SX Configuration ^ sx:fader_modules|Fader Modules ->


======XS Core - DSP unit======

The powerful 52/XS Core is an independent DSP system which does not require a PC for operation. There are no fans, hard discs or batteries inside the 52/XS Core and in the I/O boxes, allowing silent and low-maintenance operation directly in the studio.

High-performance 40-bit floating-point digital signal processing for:

  * 3-band fully parametric equalizers, subsonic filter, dynamics, limiter, delay for all 16 fader channels, mono or stereo
  * 16 summing busses (stereo), Aux busses, clean feeds and PFL
  * 6 clean feeds (mix-minus, mono or stereo)
  * 4 monitoring busses for control room and studio support
  * flexible talkback, logic and GPIO system
  * integrated routing matrix
  * internal tone generator
  * Gigabit audio network for 512 input and 512 output channels for low-latency interconnection between 52/XS cores or to other DHD products
  * internal or external 48 kHz or 44.1 kHz sync

Other features of the XS Core:

  * highly efficient external wide-range power supply, Energy Star Level V, redundancy option
  * minimal system power consumption
  * expandable modular system allows optional integration of other DHD product lines
  * serial or TCP/IP interface options to radio automation or other external control systems

<WRAP center round tip 80%>
**Tip**\\  For more information on the Core Types, see [[http://dhd-audio.de/dhd_files/52sx/manual/html/52sx_modules_en/index.html|Module List]].
</WRAP>

===== Recent XS2 Cores =====

The XS2 cores are the result of constant research and development of our products.

In the following table the main differences between the 52-1810 and the 52-1830 are listed.

[{{:sx:52-1810_swx_rear-top-1b.jpg?nolink|//52-1810 rear view//}}] [{{:sx:52-1830_swx_rear-top-1b.jpg?nolink|//52-1830 rear view//}}]

^Feature^52-1810^52-1830^
/* |support for redundant power supply|yes|yes| */
|number of supported faders|12/16((16 fader (4 fader modules) are only possible if a maximum of two I/O boxes are used on the 52-1810.))|8|
|number of supported I/O boxes|2/3((Three I/O boxes are only possible if a maximum of 12 fader (3 fader modules) are used on the 52-1810.))|1/2((Two I/O boxes are only possible if PC TFT View software is used instead of TFT Module.))|
|number of audio, power & control ports (APC)|8|4|
|TCP/IP interface for external control|yes|yes|
|serial interface for external control|yes|yes|
|built-in Dante 4ch/4ch interface|yes|yes|