<- tb5:surround_configuration_2|Surround Configuration (5.1) | TB5 v7.4 ^ tb5:start|Toolbox5 Software ^ tb5:authorisation_overview|Authorisation Overview -> ====== GPIOs of an 52/MB connected to an 52/MX or 52/RM4200D ====== **Note**\\ Only the combination 52-5063**B** (frame) / 52-54**2**2A (controller module) supports the GPIO feature (the controller modules 52-5424A and 52-5425A with different fiber optical interface are also possible). Follow these steps to handle the GPIOs of a connected 52/MB: 1. In th project tree, select ''/DSP Fame I/O'',select the MADI port where the 52/MB is connected to and select the option ''56 Ch. linked 52/MB'' in the ''Number of Channels'' column. [{{ gpio_52mb_dsp-frame-io.zoom60.png?nolink |//DSP Frame I/O; defining the MADI port mode.//}}] 2. In the project tree, select ''/DSP Frame I/O/''. 3. Select the GPIO modules (52-5310 / 52-5311) on the slots'' C1 ''to'' C4 ''and label the GPIs and GPOs. [{{ gpio_52mb_port.zoom60.png?nolink |//DSP Frame I/O; inserting GPIO modules and labeling GPIs and GPOs.//}}] 4. Afterwards, you can use the GPIs and GPOs as usual. [{{ gpio_52mb_logic-functions.zoom60.png?nolink |//Logic functions; using the 52/MB GPIs.//}}] [{{ gpio_52mb_gpos.zoom60.png?nolink |//GPOs; using the 52/MB GPOs.//}}]