<- tb9:overview|Overview ^ tb9:start|Toolbox9 Software ^ tb9:project_information|Project Information ( Node) -> ====== Project Setup ====== Configuring a DHD system is a complex process. There are always different ways to do it. The sequence of the individual steps is often not static. Despite this, the following list is to be understood as a proposal, how to configure for example a brand new 52/MX. This list is neither complete nor very detailed, but it gives a basic overview of the configuration process: - Set up the general options for the project. (see [[tb9:options|Device Properties]]) - Insert a device: Right-click on the project tree and click ''Add 52/XC'', ''Add 52/XD'', ''Add RX2 base config'', ''Add 52/TX base config'' or ''Add SX2 Wizard Config''. (see [[tb9:project_information#project|Project]]) - Select the hardware I/O modules for your setup and assign the correct APC ports. (see [[tb9:io_overview|I/O Overview]]) - Create your console layout: Select the fader and control modules for your configuration and assign the correct APC ports. (see [[tb9:console|Console]]) - Set up the audio system with PGM busses, AUX busses, internal busses, fader channels etc. (see [[tb9:mixing_functions|Mixing Functions]]) - Set up the logic system to include key functions, GPIOs etc. (see [[tb9:logic|General Information on Logic]]) - Connect the audio signals and logic functions with output functions. (see [[tb9:output_functions|Output Functions]]) - Route the audio signals from the internal bus to the outputs of the hardware modules. (see [[tb9:io_overview|I/O Overview]])