APC

DHD Series 52 modules communicate with each other via single CAT5 cables. These cables use the proprietary APC technology (Audio, Power, Control). Through APC, digital audio data and electrical power are transferred, as well as core-internal control data such as logic control, TFT control data, surface control data, firmware updates. This DHD-internal standard is not intended for use with third-party equipment.

DHD standard system with GA connections and APC connections

Cable Specifications

Always use shielded CAT5, CAT5e or CAT6 Ethernet cables (at least S/UTP, F/UTP or SF/UTP) to connect modules and core devices.

The maximum length matches current Ethernet standards and must not exceed 90 meters horizontal link plus 10 meters of patch cables.

Important
Length values are standard values that work for most applications. These values can differ, especially in environments with high electromagnetic interferences.

Power over Ethernet - PoE

Power over Ethernet (PoE) is a broader term to describe any technique of transmitting electrical power along standard twisted-pair Ethernet cabling. DHD's APC technology uses a unique PoE adoption created especially for direct connection of DHD hardware. This makes additional power adaptors for every connected module unnecessary. Because of this unique design, DHD does not allow to use any 3rd party PoE inserter. Also, it is not allowed to wire APC ports of Series 52 core devices directly to network switches. If these specifications are ignored, warranty becomes immediately void.

Please consider the following warnings:

Warning
The PoE inserter (PPSA16U480POE) delivered by DHD for RM420-015/52-4015 cannot be used for 52-1156 (52/TX) and 52-4510! This PoE inserter delivers only 15 W. 52-1156 (52/TX) and 52-4510 need 20 W for operation.

To connect a 52-1156 or 52-4510 module via fibre-optic cable, use a DHD Concentrator (52-7310, 52-7300).

Warning
Usage of PoE+ inserters of other manufacturers is not allowed because they feed 56 V. DHD devices are designed for 48 V.

Warning
Usage of self-made 48V feeder adaptors for feeding 48 V is not allowed and may cause serious damage to all devices.