← Configuring Mute Logics  
 Switchable Inserts →

Selector Source Lists

On this tab, you can configure signal lists (Selector Source Lists) that are required for configuring the selectors.

Up to 10 different signal lists with a total of 250 entries are available. For example up to 10 lists with 25 entries each or a list of 250 entries can be configured.

To configure a signal list, follow these steps:

  1. In the Selector Source Lists area, select a source list from the list.
  2. If necessary, assign a distinctive name to it by entering the name in the Label box.
  3. In the Sources area, click Add to add an audio sources entry to the list. Each row represents a stereo signal.
  4. In the Display Text box, enter a name for the list entry. This name may be up to 8 characters long.
  5. To assign an audio source for the left channel to the list entry, click Select besides the Source Left box. The Audio Sources window opens. Every signal available on the TDM bus can be used as source.
  6. In the Audio sources window, select an audio source and click Assign. Alternatively, you can double-click on the audio source or drag it from the Audio Sources window to the Source left box.
  7. To assign an audio source for the right channel to the list entry, click Select besides the Source Right box. The Audio Sources window opens. Every signal available on the TDM bus can be used as source.
  8. In the Audio sources window, select an audio source and click Assign. Alternatively, you can double-click on the audio source or drag it from the Audio Sources window to the Source right box.

To add a source above a selected source, click Insert. To delete a source, select the desired source in the list and click Remove.

Selector Source Lists, Configuring signal lists.

Note
Please note that the function Output Select using the rotary encoders in the fader strips of an RM4200D can only show up to 4 digits. In the display of the control modules of an RM4200D, 8 digits can be shown if Output Select is operated by Access key. For modules of the Series 52, there are no limitations for the display of this function, because they can show up to 32 digits.

If you want to change the sequence of the entries in the list, you can do this by drag & drop. The button Clear List, in the Selector Source Lists area completely deletes the contents of the selected list!

The last selector positions are kept after rebooting the device. After a firmware reset, they are set to entry Nr 1 in the list.

← Configuring Mute Logics  
Toolbox5 Software  
 Switchable Inserts →