Differences

This shows you the differences between two versions of the page.

--- installation:update [2019/04/08 10:06]
admin [Update within Firmware 8.1 or 8.2 or 9.0]
+++ installation:update [2019/04/08 10:08]
admin [Update Firmware 8.2 to Firmware 9.0]
@@ Line 1: / Line 1: @@
 ===== Firmware Update =====
+==== Update within Firmware 9.0 ====
+Follow these steps for a firmware update:
+  - Download the current, related versions of Toolbox9 and firmware (*.fw9) from [[update:start|the update section of support.dhd.audio (Login required)]]
+  - Replace your old Toolbox9.exe by the new version.
+  - Start Toolbox9, make sure you are connected to the system, which will be updated.
+  - Open your configuration file from your hard disk and save it **under a new name**. That way you have a backup of the old configuration file.
+  - Start the update process with [[tb9:start|Toolbox9]] > [[tb9:maintenance:start|Maintenance Window]] > [[tb9:maintenance:update|Update]] > Device Firmware. In the opening dialogue, select the update file you have downloaded.
+  - After updating the system successfully, Toolbox9 proposes to restart the system or not. Without an immediate restart, the system will run with the old firmware until the next restart is done.
+  - Send your configuration file to the device
+//During an update process, we recommend not to press any button on the console.//
 ==== Update Firmware 8.2 to Firmware 9.0 ====
@@ Line 13: / Line 25: @@
   - Open your configuration file from your hard disk and save it **under a new name**. That way you have a backup of the old configuration file.
   - Perform any changes on your configuration regarding hardware changes as described [[tb9:upgrade_9_0#upgrade_instructions|here]] and also check the [[tb8:project_information#information|Project Information Section]] for potential issues. We also suggest you to check your TFT views and all other points of the configuration where changes were neccessary and may have been performed automatically. You will not be able to send your configuration to the device if hardware configuration does not match the requirements.
-  - Start the update process with [[tb8:start|Toolbox9]] > [[tb8:maintenance:start|Maintenance Window]] > [[tb8:maintenance:update|Update]] > Device Firmware. In the opening dialogue, select the update file you have downloaded.
+  - Start the update process with [[tb9:start|Toolbox9]] > [[tb9:maintenance:start|Maintenance Window]] > [[tb9:maintenance:update|Update]] > Device Firmware. In the opening dialogue, select the update file you have downloaded.
   - After updating the system successfully, Toolbox9 proposes to restart the system or not. Without an immediate restart, the system will run with the old firmware until the next restart is done.
   - Send your configuration file to the device