Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
installation:update [2019/04/08 10:07] admin |
installation:update [2019/04/08 10:08] admin [Update Firmware 8.2 to Firmware 9.0] |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| ==== Update Firmware 8.2 to Firmware 9.0 ==== | ==== Update Firmware 8.2 to Firmware 9.0 ==== | ||
| - | <WRAP center round alert 60%> | + | <WRAP center round alert 80%> |
| **Warning**\\ Before updating, make sure to check if your hardware is still supported in version 9.x. See [[tb9:upgrade_9_0|Toolbox9 upgrade instructions]]. | **Warning**\\ Before updating, make sure to check if your hardware is still supported in version 9.x. See [[tb9:upgrade_9_0|Toolbox9 upgrade instructions]]. | ||
| </WRAP> | </WRAP> | ||
| Line 25: | Line 25: | ||
| - Open your configuration file from your hard disk and save it **under a new name**. That way you have a backup of the old configuration file. | - Open your configuration file from your hard disk and save it **under a new name**. That way you have a backup of the old configuration file. | ||
| - Perform any changes on your configuration regarding hardware changes as described [[tb9:upgrade_9_0#upgrade_instructions|here]] and also check the [[tb8:project_information#information|Project Information Section]] for potential issues. We also suggest you to check your TFT views and all other points of the configuration where changes were neccessary and may have been performed automatically. You will not be able to send your configuration to the device if hardware configuration does not match the requirements. | - Perform any changes on your configuration regarding hardware changes as described [[tb9:upgrade_9_0#upgrade_instructions|here]] and also check the [[tb8:project_information#information|Project Information Section]] for potential issues. We also suggest you to check your TFT views and all other points of the configuration where changes were neccessary and may have been performed automatically. You will not be able to send your configuration to the device if hardware configuration does not match the requirements. | ||
| - | - Start the update process with [[tb8:start|Toolbox9]] > [[tb8:maintenance:start|Maintenance Window]] > [[tb8:maintenance:update|Update]] > Device Firmware. In the opening dialogue, select the update file you have downloaded. | + | - Start the update process with [[tb9:start|Toolbox9]] > [[tb9:maintenance:start|Maintenance Window]] > [[tb9:maintenance:update|Update]] > Device Firmware. In the opening dialogue, select the update file you have downloaded. |
| - After updating the system successfully, Toolbox9 proposes to restart the system or not. Without an immediate restart, the system will run with the old firmware until the next restart is done. | - After updating the system successfully, Toolbox9 proposes to restart the system or not. Without an immediate restart, the system will run with the old firmware until the next restart is done. | ||
| - Send your configuration file to the device | - Send your configuration file to the device | ||