Differences

This shows you the differences between two versions of the page.

--- installation:update [2020/02/18 12:33]
ma [Update Firmware 9.0 to Firmware 9.1]
+++ installation:update [2020/02/20 10:49]
he
@@ Line 4: / Line 4: @@
 <WRAP center round alert 80%>
-**Warning**\\  Before updating, make sure to check if your hardware is still supported in version 9.x. See [[tb9:upgrade_9_0|Toolbox9 upgrade instructions]].
+**Warning**\\  Before updating, make sure to check if your hardware is still supported in version 9.1.x. See [[tb9:upgrade_9_1|Toolbox9.1 upgrade instructions]].
 </WRAP>
@@ Line 11: / Line 11: @@
   - Replace your old Toolbox9.exe by the new version.
   - Start Toolbox9, make sure you are connected to the system, which will be updated.
-  - Toolbox9 v9.1 will automatically install version DHDCS v3.0.\\ \\ <WRAP center round info 80%>**Note**\\  From version 9.1 the DHDCS v3.0 will replace the task of Toolbox's Maintenance Window and includes all required tools for system maintenace and firmware updates.\\  </WRAP>
+  - Toolbox9 v9.1 will automatically install version DHDCS v3.0.\\ \\ <WRAP center round info 80%>**Note**\\  From version 9.1 the DHDCS v3.0 replaces Toolbox's Maintenance Window and includes all required tools for system maintenace and firmware updates.\\  </WRAP>
   - Open your configuration file from your hard disk and save it **under a new name**. That way you have a backup of the old configuration file.
   - Perform any changes on your configuration regarding hardware changes as at [[tb9:upgrade_9_1#upgrade_instructions|Version 9.1 release notes and upgrade instructions]] and also check the [[tb9:project_information#information|Project Information Section]] for potential issues. You will not be able to send your configuration to the device if hardware configuration does not match the requirements.
@@ Line 20: / Line 20: @@
 //During an update process, we recommend not to press any button on the console.//
 ==== Update within Firmware 9.0 ====