Differences

This shows you the differences between two versions of the page.

--- installation:update [2020/02/20 10:49]
he
+++ installation:update [2023/04/06 12:42]
he
@@ Line 1: / Line 1: @@
-===== Firmware Update =====
+===== Firmware Update XC2/XD2/XS2, XD/XD/XS  =====
+==== Update Firmware 9.1 to Firmware 9.2 ====
+<WRAP center round alert 80%>
+**Warning**\\  Before updating, make sure to check if your hardware is still supported in version 9.2.x. See [[tb9:upgrade_9_2|Version 9.2 upgrade instructions]].
+</WRAP>
+Follow these steps for a firmware update:
+  - Download the current, related versions 9.2 of Toolbox and firmware (*.fw9) from [[update:start|the update section of support.dhd.audio (Login required)]]
+  - Replace your old Toolbox9.exe by the new version.
+  - Start Toolbox, make sure you are connected to the system, which will be updated.
+  - Open your configuration file from your hard disk and save it **under a new name**. That way you have a backup of the old configuration file.
+  - Perform any changes on your configuration regarding hardware changes as at [[tb9:upgrade_9_2#upgrade_instructions|Version 9.2 release notes and upgrade instructions]] and also check the [[tb9:project_information#information|Project Information Section]] for potential issues. You will not be able to send your configuration to the device if hardware configuration does not match the requirements.
+  - Start the update process with [[DHDCS:v3:start|DHDCS]] > [[DHDCS:v3:Update|Update]] > Update Firmware. In the opening dialogue, select the update file you have downloaded.
+  - After updating the system successfully, DHDCS proposes to restart the system or not. Without an immediate restart, the system will run with the old firmware until the next restart is done.
+  - Send your v9.2 configuration file to the device
+//During an update process, we recommend not to press any button on the console.//
 ==== Update Firmware 9.0 to Firmware 9.1 ====
@@ Line 8: / Line 26: @@
 Follow these steps for a firmware update:
-  - Download the current, related versions 9.1 of Toolbox9 and firmware (*.fw9) from [[update:start|the update section of support.dhd.audio (Login required)]]
+  - Download the current, related versions 9.1 of Toolbox and firmware (*.fw9) from [[update:start|the update section of support.dhd.audio (Login required)]]
   - Replace your old Toolbox9.exe by the new version.
   - Start Toolbox9, make sure you are connected to the system, which will be updated.