Differences

This shows you the differences between two versions of the page.

--- network:ip [2018/05/09 15:57]
127.0.0.1 external edit
+++ network:ip [2019/03/11 15:49]
@@ Line 1: / Line 1: @@
-<- network:protocols|Protocols & Ports used ^ network:start|Network Specifications ^ network:\\END ->
-====== IP Basic Settings & Configuration ======
-===== IP Basic Settings =====
-Before delivery, each Series 52 system is configured with an IP basic setting. This setting has a certain pattern, unless the customer indicates different requirements in his order.
-Each controller with an integrated Ethernet interface has a dedicated network address, the so-called MAC address (''MAC - Media Access Control''). This address is always unambiguous and unique. DHD owns the MAC address range ''00:0A:63:00:00:00'' to ''00:0A:63:FF:FF:FF'', therefore this address is also referred as serial number of a DHD device.
-A network-compatible controller module is always identified in a network by its MAC address. As the first 3 Bytes of all DHD MAC addresses always are identical, only the last 3 Bytes are indicated in DHD software applications.
-<WRAP center round info 80%>
-**Note**\\  If you find the term "MAC address" in the context of a DHD system, it always refers to the last three Bytes of the actual address, although this is, strictly speaking, incorrect.
-</WRAP>
-<WRAP center round important 80%>
-**Important**\\  These last 3 Bytes of the MAC address are used for generating the IP address for the basic setting.
-</WRAP>
-Find below an example for the MAC address 10:00:02
-  * Every single Byte is translated into the decimal format: ''10h = 16, 00h = 0, 02h = 2''
-  * Afterwards the decimal numbers are strung together; 10 is prepended, and all numbers are separated by periods: ''10.16.0.2''
-The subnet mask is automatically set to ''255.0.0.0'', according to the classification of this IP range.
-Thus the following IP basic setting results for the example device:
-  * ''IP address: 10.16.0.2''
-  * ''Subnet mask: 255.0.0.0''
-===== IP Configuration =====
-<WRAP center round tip 80%>
-**Tip**\\  See also [[tb8:maintenance:start|Maintenance Documentation]].
-</WRAP>
-The IP settings of a Series 52 system are defined directly in the systems communication controller. To set IP parameters, use the ''Maintenance Window'', an application, which is implemented in [[tb5:start|Toolbox5]], [[tb8:start|Toolbox8]], [[sx:start|SXConfig]] and [[dx:start|DXConfig]].
-You can open the Maintenance Window by clicking the according command in the ''View'' menu or by pressing ''F7'' on your keyboard.
-{{ :tb8:maintenance:maintenance_device_overview.png?direct&600 |//Maintenance Window with device selection list on the left hand side//}}
-In the ''Device'' menu, select ''Network Config...''.
-{{page>tb8:maintenance:device#network_config&noheader}}