Buses

On the Buses page you can configure the settings for all buses that are available in the SX2 system.

SX2Config Software - Buses

In the following tables, all options on this page are explained.

element description
Talk 1 SourceClick the button, next to the Talk 1 Source box. The Audio Sources window opens. Select an audio source from the list and click assign.
When the Talk 1 Condition logic becomes true, the Talk 1 Source is active on the corresponding bus.
Talk 2 SourceClick the button, next to the Talk 2 Source box. The Audio Sources window opens. Select an audio source from the list and click assign.
When the Talk 2 Condition logic becomes true, the Talk 2 Source is active on the corresponding bus.
Talk AttenuationWhen a Talk Source is active, the busses can be attenuated between 0 dB and Off in steps of 1 dB. Use the Talk Attenuation selector to change the attenuation value.
column description
Bus nameHere you can find the name of the bus for which you configure the following settings.
StereoSelect this check box, if the bus is stereo. Clear the check box to configure the bus as mono.
Talk 1 ConditionClick the button, next to the Talk 1 Condition box. The Logic Sources window opens. Select a logic source from the list and click assign.
When this logic source becomes true, the Talk 1 Source is active on the corresponding bus.
Talk 2 ConditionClick the button, next to the Talk 2 Condition box. The Logic Sources window opens. Select a logic source from the list and click assign.
When this logic source becomes true, the Talk 2 Source is active on the corresponding bus.
LimiterSelect the On check box to activate the limiter for this bus.
Select a threshold value from the drop-down menu (-30 dB to 20 dB).
CF SourceSelect from the drop-down menu an audio source for your clean feed signal
Use Output selectSelect this check box to enable source selection for the alternative clean feed signal.
Add to Selector List 1Select this check box to add a bus to source list 1. This bus will be available in the monitor source list, which is assigned to the SEL key on 52-5614 central module.
Add to Selector List 2Select this check box to add a bus to source list 2. This bus will be available for monitoring in the Monitor 2 list, which is available in the Monitor Selector view of the TFT/Touch Display.