Differences
This shows you the differences between two versions of the page.
|
sx:v7:xs_core [2016/06/09 15:49] marc |
sx:v7:xs_core [2019/03/11 15:49] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | <- ^ sx:start|SXConfig ^ sx:fader_modules|Fader Modules -> | ||
| - | ======XS Core - DSP unit====== | ||
| - | The powerful 52/XS Core is an independent DSP system which does not require a PC for operation. There are no fans, hard discs or batteries inside the 52/XS Core and in the I/O boxes, allowing silent and low-maintenance operation directly in the studio. | ||
| - | |||
| - | High-performance 40-bit floating-point digital signal processing for: | ||
| - | |||
| - | * 3-band fully parametric equalizers, subsonic filter, dynamics, limiter, delay for all 16 fader channels, mono or stereo | ||
| - | * 32 summing busses (mono), Aux busses, clean feeds and PFL | ||
| - | * 6 clean feeds (mix-minus, mono or stereo) | ||
| - | * 4 monitoring busses for control room and studio support | ||
| - | * flexible talkback, logic and GPIO system | ||
| - | * integrated routing matrix | ||
| - | * internal tone generator | ||
| - | * Gigabit audio network for 512 input and 512 output channels for low-latency interconnection between 52/XS cores or to other DHD products | ||
| - | * internal or external 48 kHz or 44.1 kHz sync | ||
| - | |||
| - | Other features of the XS Core: | ||
| - | |||
| - | * highly efficient external wide-range power supply, Energy Star Level V, redundancy option | ||
| - | * minimal system power consumption | ||
| - | * expandable modular system allows optional integration of other DHD product lines | ||
| - | * serial or TCP/IP interface options to radio automation or other external control systems | ||
| - | |||
| - | <WRAP center round tip 80%> | ||
| - | **Tip**\\ For more information on the Core Types, see [[http://dhd-audio.de/dhd_files/52sx/manual/html/52sx_modules_en/index.html|Module List]]. | ||
| - | </WRAP> | ||
| - | |||
| - | ===== XS Cores ===== | ||
| - | |||
| - | In the following table the main differences between the 52-1801 and the 52-1804 are listed. | ||
| - | |||
| - | |**Feature**|**52-1801**|**52-1804**| | ||
| - | |support for redundant power supply|yes|yes| | ||
| - | |number of supported faders|12/16*|8| | ||
| - | |number of supported I/O boxes|2/3%%**%%|1| | ||
| - | |number of audio, power & control ports (APC)|8|4| | ||
| - | |serial interface for external control|yes|yes| | ||
| - | |TCP/IP interface for external control|yes|yes| | ||
| - | |||
| - | * 16 fader (4 fader modules) are only possible if a maximum of two I/O boxes are used on the 52-1801. | ||
| - | |||
| - | %%**%% Three I/O boxes are only possible if a maximum of 12 fader (3 fader modules) are used on the 52-1801. | ||