Differences
This shows you the differences between two versions of the page.
sx:xs_core [2016/11/29 18:33] go [XS Core - DSP unit] |
sx:xs_core [2020/06/04 10:41] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | <- sx:start|SX Configuration Manual ^ sx:start|52/SX Configuration ^ sx:fader_modules|Fader Modules -> | ||
- | |||
- | |||
- | |||
- | |||
- | |||
- | ======XS Core - DSP unit====== | ||
- | |||
- | The powerful 52/XS Core is an independent DSP system which does not require a PC for operation. There are no fans, hard discs or batteries inside the 52/XS Core and in the I/O boxes, allowing silent and low-maintenance operation directly in the studio. | ||
- | |||
- | High-performance 40-bit floating-point digital signal processing for: | ||
- | |||
- | * 3-band fully parametric equalizers, subsonic filter, dynamics, limiter, delay for all 16 fader channels, mono or stereo | ||
- | * 16 summing busses (stereo), Aux busses, clean feeds and PFL | ||
- | * 6 clean feeds (mix-minus, mono or stereo) | ||
- | * 4 monitoring busses for control room and studio support | ||
- | * flexible talkback, logic and GPIO system | ||
- | * integrated routing matrix | ||
- | * internal tone generator | ||
- | * Gigabit audio network for 512 input and 512 output channels for low-latency interconnection between 52/XS cores or to other DHD products | ||
- | * internal or external 48 kHz or 44.1 kHz sync | ||
- | |||
- | Other features of the XS Core: | ||
- | |||
- | * highly efficient external wide-range power supply, Energy Star Level V, redundancy option | ||
- | * minimal system power consumption | ||
- | * expandable modular system allows optional integration of other DHD product lines | ||
- | * serial or TCP/IP interface options to radio automation or other external control systems | ||
- | |||
- | <WRAP center round tip 80%> | ||
- | **Tip**\\ For more information on the Core Types, see [[http://dhd-audio.de/dhd_files/52sx/manual/html/52sx_modules_en/index.html|Module List]]. | ||
- | </WRAP> | ||
- | |||
- | ===== Recent XS2 Cores ===== | ||
- | |||
- | The XS2 cores are the result of constant research and development of our products. | ||
- | |||
- | In the following table the main differences between the 52-1810 and the 52-1830 are listed. | ||
- | |||
- | [{{:sx:52-1810_swx_rear-top-1b.jpg?nolink|//52-1810 rear view//}}] [{{:sx:52-1830_swx_rear-top-1b.jpg?nolink|//52-1830 rear view//}}] | ||
- | |||
- | ^Feature^52-1810^52-1830^ | ||
- | /* |support for redundant power supply|yes|yes| */ | ||
- | |number of supported faders|12/16((16 fader (4 fader modules) are only possible if a maximum of two I/O boxes are used on the 52-1810.))|8| | ||
- | |number of supported I/O boxes|2/3((Three I/O boxes are only possible if a maximum of 12 fader (3 fader modules) are used on the 52-1810.))|1/2((Two I/O boxes are only possible if PC TFT View software is used instead of TFT Module.))| | ||
- | |number of audio, power & control ports (APC)|8|4| | ||
- | |TCP/IP interface for external control|yes|yes| | ||
- | |serial interface for external control|yes|yes| |