Network Settings

Network Settings page allows you to edit and set up network related settings of the core device.

Network Settings page

• Device Name: the hardware name of the core device.

Network settings section can change the settings of the ETH interface of the core device. The following settings can be changed:

• IP Address
• Subnet Mask
• Broadcast Address
• Gateway
• Use DHCP

In the NTP settings section you can add one Primary time server such as up to two additional (fallback) time servers.

Setup Timezone and DST page requires a valid user login with Configuration and Maintenance rights to view and edit these settings. See Toolbox setup & user management.

To setup your devices timezone:

• Set Offset from UTC (GMT) to local time
• Click Save at the bottom of the page

To setup DST:

• Check Use DST to enable automatic DST switching
• Setup Offset from UTC (GMT) to local DST time
• Select begin and end time of DST
• Click Save at the bottom of the page

Setup SNMP page requires a valid user login with Configuration and Maintenance rights to view and edit these settings. See Toolbox setup & user management.

To setup SNMP:

• In Toolbox configuration, go to <Device>, Options Tab and check Use 52-8591 SNMP Support.
• Optional: In Toolbox configuration, go to <Device> / I/O Overview, click Add and select SNMP User Logics Virtual SNMP Module. Now you can add up to 20 custom logical sources and also send traps on status change if configured.
• Check Enable SNMP to enable SNMP on the firmware side.
• Select SNMP Version. Versions available are SNMP V1 and SNMP V2c.
• Set your Community ID.
• Add your SNMP Server to the Whitelist. To do so, enter SNMP Server IP and click + icon on the right of the input field. This is required for security reasons.
• Optional: Add one or more Trap Receiver by entering their IP and clicking + icon on the right of the input field. Then Check System Traps ON.