Differences

This shows you the differences between two versions of the page.

--- network:general [2016/06/07 10:18]
marc created
+++ network:general [2017/11/13 15:12]
go [General Settings]
@@ Line 1: / Line 1: @@
+<- network:hardware|Recommended Network Switches ^ network:start|Network Specifications ^ network:protocols|Protocols & Ports used ->
-The Ethernet port of a DHD device complies to the standard 100Base-TX, IEEE 802.3u. This means that the network connected to it must run at least with a speed of 100 Mbit/s. Never try to connect a DHD device to a network running on 10 Mbit/s! Even if it looks like this might work, in fact it will not!
-The Ethernet interface of a DHD device operates with the following speed:
->100 Mbps - Half Duplex
-If you connect other network equipment to a DHD device, please ensure it is able to handle these specifications. However, if you experience connection problems, make sure the requirements are met. This is particularly important if you connect a PC directly to a DHD device using a crossover Ethernet cable. If you do this, make sure you have set the properties of the network adapter to the right values. Most network adapters have an "Auto-Detect" option - please use it!
+====== General Settings ======
+The Ethernet port of a DHD device complies to the standard 100Base-TX IEEE 802.3u (52/XC, 52/XD, 52/XS) and 1000BASE-T (52/XC2, 52/XD2, 52/XS2).
+<WRAP center round alert 80%>
+**Warning**\\  Never try to connect a DHD device to a network running on 10 Mbit/s! \\ Even if it looks like this might work, in fact it will not!
+</WRAP>
+/* The Ethernet interface of a DHD device operates with the following speed:
+>100 Mbps - Half Duplex */
+If you connect other network equipment to a DHD device, please ensure it is able to handle these specifications. However, if you experience connection problems, make sure the requirements are met. This is particularly important if you connect a PC directly to a DHD device using a crossover Ethernet cable. If you do this, make sure you have set the properties of the network adapter to the right values. Use "Auto-Detect" option, that are provided by the most network adapters.
 <WRAP center round important 80%>