Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
network:general [2017/06/28 13:20]
127.0.0.1 external edit
network:general [2017/11/13 15:12]
go [General Settings]
Line 17: Line 17:
 ====== General Settings ====== ====== General Settings ======
  
-The Ethernet port of a DHD device complies to the standard 100Base-TXIEEE 802.3u. This means that the network connected to it must run at least with a speed of 100 Mbit/s. Never try to connect a DHD device to a network running on 10 Mbit/s! Even if it looks like this might workin fact it will not!+The Ethernet port of a DHD device complies to the standard 100Base-TX IEEE 802.3u ​(52/XC, 52/XD52/XS) and 1000BASE-T (52/XC2, 52/XD2, 52/​XS2). ​
  
-The Ethernet interface of a DHD device ​operates with the following speed:+<WRAP center round alert 80%> 
 +**Warning**\\ ​ Never try to connect ​a DHD device ​to a network running on 10 Mbit/s! \\ Even if it looks like this might work, in fact it will not! 
 +</​WRAP>​
  
->100 Mbps - Half Duplex+/* The Ethernet interface of a DHD device operates with the following speed:
  
-If you connect other network equipment to a DHD device, please ensure it is able to handle these specifications. However, if you experience connection problems, make sure the requirements are met. This is particularly important if you connect a PC directly to a DHD device using a crossover Ethernet cable. If you do this, make sure you have set the properties of the network adapter to the right values. ​Most network adapters have an "​Auto-Detect"​ option ​- please use it!+>100 Mbps - Half Duplex */ 
 + 
 +If you connect other network equipment to a DHD device, please ensure it is able to handle these specifications. However, if you experience connection problems, make sure the requirements are met. This is particularly important if you connect a PC directly to a DHD device using a crossover Ethernet cable. If you do this, make sure you have set the properties of the network adapter to the right values. ​Use "​Auto-Detect"​ option, that are provided by the most network adapters.
  
 <WRAP center round important 80%> <WRAP center round important 80%>