Using Remote Control Views

Double click a remote view in the Remote Control branch to open the desired remote control view. For a better workflow, it is possible to open several remote control views at once in different tabs to quickly switch between them.

Which elements are shown in a remote view depends on the configuration of the view (see Creating Remote Control Views).

Basically, all elements are working in an analogous manner as the elements of the hardware modules.

You can move a fader up and down using drag'n'drop. You can also set special values directly:

• Press Ctrl key and click the desired fader with the left mouse button to set the fader to 0dB.
• Press Alt key and click the desired fader with the left mouse button to set the fader to -oodB (OFF)
• Press Shift key and click the position you are pointing and clicking to. The fader jumps directly to this position.

The hardware encoders are represented in the remote control software by the following symbol: .

The functions of the encoder are split to three buttons:

• Upper button : increment a value like turning the encoder to the right.
• Lower button : decrement a value like turning the encoder to the left.
• Center button : Simulate pressing the encoder.

If the device holds a DHDOM DSP Control software license and the fader strips of the remote view include Access keys, the DSP parameters of a fader channel can be displayed in a separate window. Therefore, press and hold the Ctrl key on your keyboard and click the Access button of the desired fader strip.